Ceramic particle adhesive has good low temperature resistance, high temperature resistance, aging resistance, and low cost. Ceramic particle pavement has low temperature and is conducive to use in cold regions. Excellent thermal aging performance, good high-temperature stability, effectively extending the service life of roads. The construction cost is relatively low. 50% of other similar colored pavement solutions. Below, the editor has compiled an introduction to glue.
Ceramic particle adhesive polyurethane waterproof coating has been applied 2-4 times. Ceramic particles are artificial particles with a ceramic texture, which have high comprehensive strength, good fire resistance, and good weather resistance. Ceramic particle adhesive is now mainly used in high-rise buildings to reduce the floor pressure caused by high-rise building decoration and construction. This ceramic particle has the advantages of uniform particle size, high strength, porous surface, criss crossing internal network, not easy to harden, strong adsorption, long service life, light weight, thermal insulation, noise reduction, and non toxicity. Aseptic, non radioactive, good insulation effect. The joints between the wall and the ground, as well as the joints between the water supply and drainage pipes and the ground, are prone to leakage. These corners need to be handled properly. Apply ceramic particle adhesive on site. Require construction personnel to provide cement root protection for the water supply and drainage pipes in the bathroom. Then re waterproof the ground and add the original waterproof layer to form a composite waterproof layer, enhancing the waterproof performance.
Before using high-temperature ceramic adhesive, the surface of the ceramic particle adhesive bonded part should be polished with a 100-120 grit sandpaper and then degreased, if possible. Glue dries faster at room temperature. Normally, 600g of glue is used at once. Please use it within 30 minutes. Use a container with a larger bottom area. Please prepare before use. Use as much as you need.
Ceramic particle adhesive is a high-performance, high-temperature resistant, wear-resistant, and corrosion-resistant polymer ceramic material composed of composite materials such as alumina, silicon carbide, silicon carbide, titanium alloy, etc. ）Modified toughened heat-resistant resin is widely used for the preparation of wear-resistant coatings on various mechanical parts, with characteristics such as high temperature resistance, wear resistance, and corrosion resistance. The composition of the coating is inert material, which is not affected by environmental media and has excellent chemical corrosion resistance. Adopting a multi-directional network to enhance processing and overall construction effectively prevents paint damage and peeling.
Editor: Lynn
