Colored ceramic particle anti-skid pavement is made by applying a special polymer resin adhesive to the road surface, spraying different colored wear-resistant aggregates, and paving them in accurate quantities. What is the construction process of it?
The specific construction process is as follows
1、 Road base requirements: If it is an asphalt base, the colored ceramic particle anti-skid pavement should be laid 2 months after the pavement is poured. If it is a concrete base, the ceramic particle anti-skid pavement should be laid 1 month after the pavement is poured.
2、 Road base cleaning: Use a high-pressure water gun to clean the road surface. After the road surface is dry, use a road vacuum cleaner or hair dryer to clean all dust and impurities on the road surface. If there are potholes or damages on the road surface, they need to be repaired first.
3、 Bottom coating treatment: Use a rubber scraper to evenly apply and cure PU801 polyurethane adhesive. Depending on the porosity of the road, it is about 1.5-1.8kg/kg
4、 Throwing colored ceramic sand: Evenly throw the colored ceramic sand onto the bottom special floor adhesive, and cover the floor adhesive completely with a margin of 5-6 kg/. The ceramic sand particles thrown should be controlled within 1-3 mm.
The above is the specific construction process of colored ceramic particle anti-skid pavement, which is a new road beautification technology. The traditional black asphalt concrete and gray cement concrete pavement have become pleasing to the eye and have good anti slip effects through colored construction.
Editor: Nancy
