Ceramic particles are a widely used new type of pavement material, characterized by anti slip, wear-resistant, environmentally friendly, corrosion-resistant, and low water absorption rate. It has the characteristics of not fading, being hard and firm, and having a long service life. It needs to be backfilled after installation in the bathroom, considering waterproofing.
Backfilling steps:
Firstly, plan to install the equipment, use fine sand cement as the slope of the flowing water according to the location of the floor drain, and then backfill with ceramic particles.
After the planning is completed, use waterproof coating to stick or brush more than 30 cm on the wall. A certain construction height should be maintained near the sewer for waterproofing.
3. Moisturizing experiment: After blocking the entire toilet, pour water into the toilet, maintain the threshold height, and wait for 1-2 days.
When going downstairs, pay attention to observing that the water level does not drop or checking for leaks, so that the floor tiles and supporting facilities can be constructed. At the same time, ensure that all pipeline joints are waterproof and sealed with cement slurry.
The above is the work that needs to be done after installing ceramic particles in the bathroom. It can also be used for road marking on highways, airport runways, train stations, subways, bus stations, parking lots, parks, squares, schools, hotels, restaurants, and more.
Editor: Nancy
